Three Major Considerations in LED High Pole Light Installation

First, when the preparation stage, according to the loading and packing list, check whether it is damaged, bending, distorting, whether the zinc layer is destroyed, pay attention to the signage of the stem of each pole indicate the type, set number, and segmentation In the inside of the rod, it indicates that the weight of the rod is correct. If the goods are correct, whether the crane lifting capacity is sufficient, in addition, in accordance with the larger and minimum sleeve length provided on the drawings, make a tag on the rod on the rod. Use it when used.

Second, during the installation process, each splicing is provided with a set length, but due to the impact of manufacturing, installation errors and physical factors, there is a change in the length of the socket, so that larger the length and the minimum sleeve length are provided. In order to make the installation, you may need to lubricate the fitting surface. Be careful not to use lubricants to prevent and pollute the pole, and can be used to connect the inside and outside surface with soap water. At the end of the socket, the necessary force is applied at both ends to obtain a tight junction.

Third, it should be noted when installing is that the fixed nut connecting the beam must be tightened with a wrench, often seeing the light head of the outdoor high pole light, all because there is no fixed screw. Falling will also cause personal injury, the LED high pole light pole is generally composed of two or three steel pipes. The two-section pole plug-in depth must not be less than 60cm, the top is fixed, which is basically three M14 or M16. The screw links, it is necessary to pay attention to the installation. These three screws must be stainless steel screws. Many LED high pole lamp manufacturers are ignored. Using ordinary iron galvanized screws, the time is long, the latter will seriously rust, It is difficult to cause irritating difficulties or cannot be detached. After the problem of high pole lamp lamps, the lamp cannot be lifted.. If the LED luminaire is installed on the high pole lights, the drive power is zero line, the fire line, and the ground, when wiring, the ground line must be connected to the main cable in advance, if the power is driven If the ground is not connected, it hits the thunderstorm, there is a certain chance to be burned.. It is also necessary to pay attention to the processing of the joint head, and the wire connector must be tinsel, then wrapped in the insulating tub, then set up the wax tube, the purpose is to avoid the rapid aging of the line under the exposure of the rain, leading to high Rod lamp short circuit. Some manufacturers did not consider some of the plastic powder itself on the steel pipe itself is insulated. They sprayed plastic powder on the lightning rod, and the lightning needles did not have a conductive role. If this problem is found, it must be inform the installer, and the prototector At the top, the plastic powder is thoroughly scraped from the top of at least 25 cm, and then at the rain cap and the lightning protection interface, the mortar needed to fix the righteous needle to the mineral powder, in order to conduct normal conductivity.

All in all, in order to ensure the quality of LED high pole lights, it must be kept pay close attention to the problem of security hazards, and ensure that the brightness of the light is in an orderly, and the land is good.